Click here to end inversion of the alpha channel of 32-bit frame

Click here to invert the alpha channel of every 32-bit frame



Mouse-down here to select the field interleaving technique.



Enter 0 for no key frames, or enter the number of frames in a key set (QuickTime only)



Place the box at the left for the smallest possible compression.  Place the box at the right for the best looking compression.  Points in-between will prorate these two factors.



Mouse-down here to bring up a menu defining which compressor will be used when compression is requested.  The compression slider may modify the compression scheme.



Mouse-down here to bring up a menu controlling the displayed or recorded image size.



Mouse-down here to bring up a menu controlling the effective display or recording resolution.



Mouse-down here to bring up a menu which controls what is placed into the frame display window; full processing, limited processing, silouettes, et cetera.



Mouse-down here to bring up a menu of edge processing techniques.



Mouse-down here to bring up a menu of what will be shown or recorded (sight, sound, or both).



Mouse-down here to bring up a menu of hardware destinations (controllers, disks, windows, et cetera) for your playback or recording.



Mouse-down here to get a menu of time-code options.



You may enter a Lyon-Lamb initialization code into this location.



Enter the SMPTE code here, HH:MM:SS:FF.



Enter the controller node here, if using V/LAN in a multiple receiving node configuration, or ARTI.



Enter the Tape position here.  This is a absolute position for tape and video disks.

This field is not used if the hardware specified cannot use the absolute tape positioning, or if the SMPTE coding field is checked.



Enter the range of layers to be used here.

* (all layers)
start-
-end
start-end
layer_number



Enter the framing rate code here.

"30" = 30 frames/second.
"-5" = 5 seconds/frame.
"0" = advance on mouse click.



Enter the range of frames to be used here.

* (all frames)
start-
-end
start-end
frame_number

Click here to choose the screen onto which output will be shown, or on which tape will be shot.  Disabled because there is only one screen.

Click here to choose the screen onto which output will be shown, or on which tape will be shot.

Click here to use the Modem Port for serial communicatin. 

Currently, the Printer Port will be used.

Click here to use the Printer Port for serial communication. 

Currently, the Modem Port will be used.

Click here to disable the ability of this exposure sheet to call in another (as a File field entry).

Click here to allow one exposure sheet to load another, when an exposure sheet so specifies.  Currently, such cross-exposure sheet links will be ignored.

Click here to place the (0,0) point in the upper-left corner of the screen.  (0,0) is currently at the center.

Click here to place the (0,0) point at the center of the screen.  (0,0) is currently in the upper-left corner.

Click here to turn looping off.  When looping is enabled, the exposure sheet will be shown or recorded over and over, until stopped with a command-period.

Click here to turn looping on.  When looping is enabled, the exposure sheet will be shown or recorded over and over, until stopped with a command-period.

Click here to turn frame #s off.  When frame #s are turned on, each frame will be recorded with a frame # & elapsed time in a small box in the upper left corner.

Click here to turn frame #s on.  When frame #s are turned on, each frame will be recorded with a frame # & elapsed time in a small box in the upper left corner.



Click here to reject entries without effect.



Click here to accept the entries made.